Differences

This shows you the differences between two versions of the page.

--- 3dp:sc21:start [2015/10/23 09:47] – [Some stuff I printed...] redox
+++ 3dp:sc21:start [2023/11/24 21:55] (current) – external edit 127.0.0.1
@@ Line 3: / Line 3: @@
 ## Overview
-I own a Shapercube 2.1, one of the last ones sold I think (it's #101). It's a great, sturdy printed. But it's not perfect, so, over time, I've made some changes, which I hope I will be able to document here.
+I own a Shapercube 2.1, one of the last ones sold I think (it's #101). It's a great, sturdy printer. But it's not perfect, so, over time, I've made some changes, which I hope I will be able to document here.
 * Added a fan on the RAMPS board
@@ Line 12: / Line 12: @@
 * Added a connector on the heated bed
 * [[.:fanduct|Designed a fanduct !]]
-{{ :3dp:sc21:fanduct:up.jpg?direct&250 |}}
+{{ .:fanduct:up.jpg?direct&250 |}}
 * Added a front power switch
-{{ .:sc21:dsc_0148.jpg?direct&250 |}}
+{{ .:dsc_0148.jpg?direct&250 |}}
 * Added a power plug on the back
 * Added some support so the Z-axis stays level
-{{ .:sc21:dsc_0147.jpg?direct&250 |}}
+{{ .:dsc_0147.jpg?direct&250 |}}
 * ...
 ## Some stuff I printed...
-{{.:dsc_0155.jpg?direct&220|Fun}} {{.:dsc_0151.jpg?direct&220|Tape hook}} {{.:dsc_0150.jpg?direct&220|Spool holder}}
+{{.:dsc_0155.jpg?direct&200|Fun}} {{.:dsc_0151.jpg?direct&200|Tape hook}} {{.:dsc_0150.jpg?direct&200|Spool holder}}
-{{.:dsc_0194.jpg?direct&220|Chain mount}}
+{{.:dsc_0194.jpg?direct&200|Loop alien}}