3dp:sc21
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
3dp:sc21 [2013/12/18 16:46] – created redox | 3dp:sc21 [2013/12/28 17:06] – [Some stuff I printed...] redox | ||
---|---|---|---|
Line 8: | Line 8: | ||
* Changed the hotend for a J-Head MkV-B | * Changed the hotend for a J-Head MkV-B | ||
* Added a fan on the cold part of the hotend | * Added a fan on the cold part of the hotend | ||
- | * Added a fan for cooling the prints | + | * <del>Added a fan for cooling the prints</ |
* Added a glass panel on the heated bed | * Added a glass panel on the heated bed | ||
* Added a connector on the heated bed | * Added a connector on the heated bed | ||
- | * Designed a fanduct ! | + | * [[3dp: |
+ | {{ : | ||
* Added a front power switch | * Added a front power switch | ||
+ | {{ : | ||
* Added a power plug on the back | * Added a power plug on the back | ||
* Added some support so the Z-axis stays level | * Added some support so the Z-axis stays level | ||
+ | {{ : | ||
* ... | * ... | ||
## Some stuff I printed... | ## Some stuff I printed... | ||
- | + | {{: | |
+ | {{: |