dev:nab:v2:jtag_access
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
dev:nab:v2:jtag_access [2015/11/12 12:38] – [Nabaztag:tag] redox | dev:nab:v2:jtag_access [2015/11/12 13:38] (current) – removed redox | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | # JTAG access | ||
- | ## Overview | ||
- | |||
- | As detailed on the Schematic (released in the FCC documents), the Nabaztag: | ||
- | |||
- | ## Hardware | ||
- | |||
- | |||
- | ### JTAG probe: BusBlaster | ||
- | |||
- | |||
- | |||
- | ### Nabaztag: | ||
- | |||
- | Well, of course you need a Nabaztag: | ||
- | |||
- | Grab a small flat screwdriver and remove the four screws on the base. You can also use a triangle screwdriver if you happen to have one, I don't. | ||
- | |||
- | And this is about it. the JTAG header is on the top left corner of the board. | ||
- | |||
- | Pinout is the following (top to bottom): | ||
- | |||
- | |||
- | ^ Nabaztag Pin ^ Function ^ BusBlaster pin ^ | ||
- | | 1 | ||
- | | 2 | ||
- | | 3 | ||
- | | 4 | ||
- | | 5 | ||
- | | 6 | ||
- | | 7 | ||
- | | 8 | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | ## Software: OpenOCD | ||
- | |||
- | ### Pacth and compile | ||
- | |||
- | ### Usage | ||
- | |||
- | ## Pictures | ||
- | |||
- | {{.: | ||
- | |||
- | ## Links |
/home/share/www/redox.ws/wiki/data/attic/dev/nab/v2/jtag_access.1447331930.txt.gz · Last modified: 2023/11/24 21:55 (external edit)