Differences

This shows you the differences between two versions of the page.

--- dev:nab:v2:nabgcc [2015/11/13 13:10] – [New architecture] redox
+++ dev:nab:v2:nabgcc [2023/11/24 22:23] (current) – redox
@@ Line 1: / Line 1: @@
+<!DOCTYPE markdown>
 # NabGCC
@@ Line 51: / Line 52: @@
 ## Compile
+Using the makefile in the root folder, you can build the whole firmware project with just:
+    make
+Delete the objects files, and binaries with
+    make clean
+The objects files should be in the `obj/` folder, and the binaries in the `bin/` folder.
 ## Flash
+Assuming you have OpenOCD running and connected to the target, flash a new firmware with
+    make program
 ## Debug
+You can load the firmware in GDB, and then debug your code:
+    arm-none-eabi-gdb ./bin/NabGCC.elf
+Next commands are to be typed in GDB:
+    tar ext :3333
+    mon reset init
+    load
+    # And type 'r' to start using this code
+    # Stop with Ctrl + C
+    # and it's like normal debugging !
+You can only set two breakpoints, which is quite limited... to delete all the breakpoints, just type 'd' and 'y'.
+Happy hacking !
 ## Links