Differences

This shows you the differences between two versions of the page.

--- rc:sw:fc:px4:build_from_source [2016/05/22 17:11] – [ Build] redox
+++ rc:sw:fc:px4:build_from_source [2023/11/24 21:55] (current) – external edit 127.0.0.1
@@ Line 12: / Line 12: @@
 ## Build
-### Std cmake
+### Using CMake, manual
     mkdir build/
@@ Line 18: / Line 18: @@
     cmake .. -DCONFIG=nuttx_sparky2_default
     make -j2 -l2
+    make upload
-## Recent stable/master/sparky2
+### Using the Makefile, auto mode
 You need a "recent" CMake (>= 3.3 ). On debian stable, you need to rebuild the package using the sources from testing. Uninstall sdcc before building the package, otherwise one of the tests fails :/
@@ Line 33: / Line 34: @@
   Build and upload to the board using the PX4 bootloader
-## Old
-* `make help`
-    Useful to know the available targets
-* `make BOARDS=yourtarget menuconfig`
+## Flash
-    Requires kconfig-mconf, but useful to config NuttX
-* `make BOARDS=yourtarget archives`
-    Build the NuttX OS archive for _yourtarget_
-* `make BOARDS=yourtarget yourtarget_default`
+### PX4 Bootloader
-    Build PX4 for _yourtarget_
-* `make BOARDS=yourtarget yourtarget_default upload`
+    make -j2 -l2 sparky2_bl
-    Build PX4 and upload using PX4 Bootloader (USB)
+    dfu-util -a 0 -d 0483:df11 -c 1 -i 0 -a 0 -s 0x08000000 -D sparky2_bl.bin
-### Combo
-    make BOARDS=yourtarget archives yourtarget_default upload
-If you make any change in the NuttX/, you need to delete everything and start over...
-    rm -R Archives/ Build/
-    make BOARDS=yourtarget archives yourtarget_default upload
-## Flash
-### DFU
 * https://pixhawk.org/dev/bootloader_update#updating_the_onboard_bootloader
-### PX4 Bootloader
-* https://pixhawk.org/dev/nuttx/building_and_flashing_console
+## Debug
+    #openocd -f interface/stlink-v2.cfg -f target/stm32f4x_stlink.cfg
+    openocd -f Debug/sparky2-board.cfg
-## Debug
+    # Start GDB
+    arm-none-eabi-gdb -x Debug/openocd.gdbinit ./build/src/firmware/nuttx/firmware_nuttx
-    openocd -f interface/stlink-v2.cfg -f target/stm32f4x_stlink.cfg
+    #In GDB:
-    In GDB:
+    #tar ext :3333
-    tar ext :3333
 And debug as usual...