Hydev

# xWifi

## Overview

## Useful note

  1) Connect the TX/RX/GND to to your UART/USB bridge, but not to the PC
  2) power up the devboard with the XWIFI on and WAIT 5 sec
  3) connect the UART/USB bridge to to your PC
  4) start your favorite terminal emulation program and use the appropriate COM port with 115200 baud rate. At this point the modules should start sending random [WTASK]999999 messages to your terminal window
  5) key AT#FLASH -s98305 -v1
  6) disconnect power to the dev board
  7) disconnect the UART/USB bridge
  8) connect power to the dev board and wait 5 sec
  9) Check if the AP shows up as wireless network: MT7681_Softap

## Links